Nokia 7210 - System Synchronization Commands for 7210 SAS-R6 and 7210 SAS-R12; System Synchronization Commands for 7210 SAS-Sx 110 GE, 7210 SAS-S 110 GE, and 7210 SAS-Sx 10100 GE

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
379
6.12.1.18 System Synchronization Commands for 7210 SAS-R6 and
7210 SAS-R12
config
— system
— sync-if-timing
— abort
— begin
— bits1
— input
—no shutdown
— shutdown
— interface-type {ds1 [{esf | sf}] | e1 [{pcm30crc | pcm31crc}]}
—no interface-type
— output
— line-length {110 | 220 | 330 | 440 | 550 | 660}
—no shutdown
— shutdown
—no ql-override
— ql-override {prs | stu | st2 | tnc | st3e | st3 | prc | ssua | ssub | sec}
— ssm-bit sa-bit
— commit
— ref-order first second [third] [
fourth]
—no ref-order
— ptp
— ql-override {prs | stu | st2 | tnc | st3e | st3 | prc | ssua | ssub | sec}
—no ql-override
— [no] shutdown
— ref1
— ql-override {prs | stu | st2 | tnc | st3e | st3 | prc | ssua | ssub | sec | eec1 | eec2}
—no ql-override
— [no] shutdown
— source-port port-id
—no source-port
— ref2
— ql-override {prs | stu | st2 | tnc | st3e | st3 | prc
| ssua | ssub | sec | eec1 | eec2}
—no ql-override
— [no] shutdown
— source-port port-id
—no source-port
— [no] ql-selection
— [no] revert
6.12.1.19 System Synchronization Commands for 7210 SAS-Sx 1/
10GE, 7210 SAS-S 1/10GE, and 7210 SAS-Sx 10/100GE
config
— system
— sync-if-timing