Boot Options
166
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
4.10.3.5 Procedure to Connect to a Console
Perform this procedure to establish a console connection to any platform.
1. Connect the terminal to the Console port on the front panel using the serial
cable. See Location of Console Ports on 7210 SAS Platforms for information
about the console port and its placement on the 7210 SAS platforms.
2. Power on the terminal.
3. Establish the connection by pressing the <Enter> key a few times on your
terminal keyboard.
4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
4.10.3.6 Location of Console Ports on 7210 SAS Platforms
This section provides console port information, supported variants, and modes of
operation for the following 7210 SAS platforms:
• 7210 SAS-M Console Port
• 7210 SAS-T Console Port
• 7210 SAS-R6 Console Port
• 7210 SAS-R12 Console Port
• 7210 SAS-Mxp Console Port
• 7210 SAS-Sx 1/10GE Console Port
• 7210 SAS-S 1/10GE Console Port
• 7210 SAS-Sx 10/100GE Console Port
4.10.3.6.1 7210 SAS-M Console Port
The 7210 SAS-M is a multilayer service-aware MPLS-capable switch. It supports two
modes of operation:
• access-uplink mode (only L2 uplinks)
• network mode (L2 or MPLS uplinks)
The switch is available as two variants, as follows:
• 7210 SAS-M 24F with support for up to 24 100/1000 SFP ports (see Figure 11)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
