Nokia 7210 - Virtual Chassis Command Reference; Command Hierarchies; Configuration Commands; Command Descriptions

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Virtual Chassis
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
247
5.9 Virtual Chassis Command Reference
5.9.1 Command Hierarchies
5.9.1.1 Configuration Commands
bof
— vc-stack-node {cpmA | cpmB} slot-num slot-num mac-addr mac-address
—no vc-stack-node {cpmA | cpmB}
5.9.2 Command Descriptions
5.9.2.1 Configuration Commands
5.9.2.1.1 Standalone Virtual Chassis (VC) Commands
vc-stack-node
Syntax vc-stack-node {cpmA | cpmB} slot-num slot-num mac-addr mac-address
no vc-stack-node {cpmA | cpmB}
Context bof
Platforms 7210 SAS-S 1/10GE and 7210 SAS-Sx 1/10GE: standalone-vc mode
Description This command configures the nodes that will be CPM-IMM nodes in a virtual chassis (VC).
The slot number can be set to any number from 1 to 8 as long as it is not in use by another
VC member node. The slot number identifies a specific node or card in the VC similar to the
slot ID of a card in a chassis-based system, and is used in addressing service objects created
during provisioning.
Note: See BOF Command Reference for more information about BOF commands.