7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
203
#uplinkA Port Settings:
uplinkA-port 1/1/26
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 10000
uplinkA-address 0
uplinkA-vlan 0
Default uplinkA-speed 1000
Parameters 10 — Keyword to set the link to 10 M/bps speed.
100 — Keyword to set the link to 100 M/bps speed.
1000 — Keyword to set the link to 1000Mbps speed.
10000 — Keyword to set the link to 10000Mbps speed.
uplinkB-speed
Syntax uplinkB-speed speed
Context bof
Platforms 7210 SAS-M (network mode and access-uplink mode), 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and access-uplink mode)
Description This command configures the speed for the uplinkB port when auto-negotiation is disabled in
the running configuration and the BOF.
If the port is configured to Auto-negotiate, this parameter is ignored.
#uplinkB Port Settings:
uplinkB-port 1/1/26
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 10000
uplinkB-address 0
uplinkB-vlan 0
Note: The uplinkA-autoneg command is not valid for 10gig ports. Therefore, whenever the
user selects 10gig ports as uplinkA-port, the uplinkA-autoneg command is defaulted to
no uplinkA-autoneg, speed as uplinkA-speed 10000, duplex as uplinkA-duplex full, as
shown in the following output example.
Note: The uplinkB-autoneg command is not valid for 10gig ports. Therefore, whenever the
user selects 10gig ports as uplinkB-port, the uplinkB-autoneg command defaults to no
uplinkB-autoneg, speed as uplinkB-speed 10000, and duplex as uplinkB-duplex full, as
shown in the following output example.
To Next Page
Loading...
