Nokia 7210 - Page 219

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Boot Options
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
219
boot-messages
Syntax boot-messages
Context show
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command shows boot messages generated during the last system boot.
Output The following output is an example of boot message information.
Sample Output
===============================================================================
cf1:/bootlog.txt
===============================================================================
Bootlog started for Version V-0.0.I317
Build V-0.0.I317 bootrom/mpc 7xxx
Built on Tue Jan 6 02:23:14 IST 2016 by panosbld in /panosbld/ws/panos/main
?Attempting to load from file cf1:/boot.tim
Version L-0.0.I312, Fri Jan 2 04:26:32 IST 2009 by panosbld in /panosbld/ws/panos/
uplinkB-vlan Displays the VLAN ID to be used on uplinkB
uplink-mode This parameter displays the uplink mode of the device
7210 SAS-M devices can be configured in either network mode
or access-uplink mode
no-service-ports Displays the ports on which service traffic is not processed
use-expansion-card-
type
Displays the expansion card type
console-disabled Displays the status of serial port console
eth-mgmt-disabled Displays if Ethernet management is disabled
eth-mgmt-address Displays the Ethernet management address
eth-mgmt-route Displays the Ethernet Management route
eth-mgmt-autoneg Displays if auto-negotiate is enabled
eth-mgmt-duplex Displays the mode of the Ethernet management port
eth-mgmt-speed Displays the Ethernet management speed
Table 24 Output Fields: BOF (Continued)
Label Description