Nokia 7210 - Page 333

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
333
Broadcast-client
The broadcast-client command enables listening at the global device level to SNTP
broadcast messages on interfaces with broadcast client enabled.
Use the following CLI syntax to enable listening to SNTP broadcast messages at the
global device level.
CLI Syntax: config>system>time>sntp
broadcast-client
The following example shows the command usage to enable listening to SNTP
broadcast messages at the global device level.
Example: config>system>time>sntp#
config>system>time>sntp# broadcast-client
config>system>time>sntp# no shutdown
The following is a sample configuration output of SNTP enabled with the broadcast-
client command enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
sntp
broadcast-client
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone GMT
----------------------------------------------
A:ALA-12>config>system>time#
Server-address
The server-address command configures an SNTP server for SNTP unicast client
mode.
Use the following CLI syntax to configure an SNTP server for unicast client mode.
CLI Syntax: config>system>time>sntp#
config>system>time>sntp# server-address ip-
address version version-number]
[normal|preferred] [interval seconds]