Nokia 7210 - Page 338

System Management
338
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Create
This command can be used to enable the time-range context.
Use the following syntax to create a time-range.
CLI Syntax: config>system>cron
time-range name create
The following example shows the command usage to create a time-range called
"test1".
Example: config>system>cron# time-range test1 create
config>system>cron>time-range$
Absolute
The absolute command configures a start and end time that will not repeat.
Use the following syntax to configure a non-repetitive time range.
CLI Syntax: config>system>cron>time-range$
absolute absolute-time end absolute-time
The following example shows the command usage to configure a non-repetitive time
range.
Example: config>system>cron>time-range$ absolute start 2006/05/
05,11:00 end
2006/05/06,11:01
config>system>cron>time-range$
The following is a sample configuration output of an absolute time range beginning
on May 5, 2006 at 11:00 and ending May 6, 2006 at 11:01.
A:sim1>config>system>cron>time-range# show cron time-range detail
===============================================================================
Cron time-range details
===============================================================================
Name : test1
Triggers : 0
Status : Inactive
Absolute : start 2006/05/05,11:00 end 2006/05/06,11:01
===============================================================================
A:sim1>config>system>cron>time-range#