Nokia 7210 - Page 402

System Management
402
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
hold-time
Syntax hold-time
Context config>system>oper-group
Platforms Only supported on 7210 SAS platforms configured in the access-uplink operating mode
Description Commands in this context configure hold time information.
group-down
Syntax [no] group-down time in seconds
Context config>system>oper-group>hold-time
Platforms Only supported on 7210 SAS platforms configured in the access-uplink operating mode
Description This command configures the number of seconds to wait before notifying clients monitoring
this group when its operational status transitions from down to up. A value of zero indicates
that transitions are reported immediately to monitoring clients.
The no form reverts the value to the default.
Default 0
Parameters time in seconds — Specifies the time, in seconds.
Values 0 to 3600
group-up
Syntax [no] group-up time in seconds
Context config>system>oper-group>hold-time
Platforms Only supported on 7210 SAS platforms configured in the access-uplink operating mode
Description This command configures the number of seconds to wait before notifying clients monitoring
this group when its operational status transitions from up to down.
The no form reverts the value to the default.
Default 4
Parameters time in seconds — Specifies the time, in seconds.
Values 0 to 3600