System Management
426
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
both — Both an entry in the RMON-MIB logTable and a TiMOS
logger event are generated.
none — No action is taken.
Default both
description description-string — Specifies a user configurable string that can be used to
identify the purpose of this event. This is an optional parameter and can be up to 80
characters. If the string contains special characters (#, $, spaces, and so on), the
entire string must be enclosed within double quotes.
owner owner — Specifies the creator of this alarm. This parameter is defined primarily
to allow entries that have been created in the RMON-MIB alarmTable by remote
SNMP managers to be saved and reloaded in a CLI configuration file. The owner will
not normally be configured by CLI users and can be a maximum of 80 characters.
Default TiMOS CLI
6.12.2.1.5 PTP Commands
ptp
Syntax ptp
Context config>system
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), 7210 SAS-T (network and access-uplink)
Description Commands in this context configure parameters for IEEE 1588-2008, Precision Time
Protocol.
anno-rx-timeout
Syntax anno-rx-timeout count
no anno-rx-timeout
Context config>system>ptp
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), 7210 SAS-T (network and access-uplink)
Description This command configures the PTP announce receipt timeout count in the Announce
message.
The no form of this command reverts the count to the default value.
To Next Page
Loading...
