Nokia 7210 - Page 431

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
431
network-type
Syntax network-type {sdh | sonet}
Context config>system>ptp
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), and 7210 SAS-T (network and access-uplink)
Description This command configures the codeset used to encode the QL values into PTP clockClass
values when the profile is configured for G.8265.1. The codeset is defined in G.8265.1, Table
1.
This configuration only applies to the range of values observed in the clockClass values
transmitted out of the node in Announce messages. The 7210 SAS supports the reception of
any valid value in G.8265.1, Table 1.
Default network-type sdh
Parameters sdh — Specifies the values used on a G.781 Option 1 compliant network.
sonet — Specifies the values used on a G.781 Option 2 compliant network.
peer
Syntax peer ip-address [create]
no peer ip-address
Context config>system>ptp
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), and 7210 SAS-T (network and access-uplink)
Description Commands in this context configure parameters associated with remote PTP peers.
If the clock-type is ordinary slave or boundary, and PTP is not shut down, the last peer
cannot be deleted. This prevents the user from having PTP enabled without any peer
configured and enabled.
The no form of this command deletes the specified peer.
Parameters ip-address — Specifies the IPv4 address of the remote peer.
Values a.b.c.d
create — Keyword to create the peer.
Note: The maximum supported number of PTP peers depends on the supported PTP PPS
rate on 7210 SAS platforms. Contact a Nokia representative for more information.