System Management
478
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command disconnects a user from a console, Telnet, FTP, or SSH session.
If any of the console, Telnet, FTP, SSH, or NETCONF options are specified, only the
respective console, Telnet, FTP, SSH, or NETCONF sessions are affected.
If no console, Telnet, FTP, SSH, or NETCONF options are specified, all sessions from the IP
address or from the specified user are disconnected.
Any task that the user is executing is terminated. FTP files accessed by the user will not be
removed.
A major severity security log event is created specifying what was terminated and by whom.
Parameters address ip-address — Specifies the IP address to disconnect, specified in dotted
decimal notation.
Values ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
username user-name — Specifies the name of the user.
console — Keyword to disconnect the console session.
telnet — Keyword to disconnect the Telnet session.
ftp — Keyword to disconnect the FTP session.
ssh — Keyword to disconnect the SSH session.
netconf — Keyword to disconnect the NETCONF session.
display-config
Syntax display-config [detail | index]
Context admin
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command displays the system’s running configuration.
By default, only non-default settings are displayed.
Parameters detail — Displays default and non-default configuration parameters.
index — Displays only persistent-indexes.
To Next Page
Loading...
