Nokia 7210 - Page 511

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
511
Context config>port>ethernet>lldp>dstmac
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables LLDP notifications.
The no form of this command disables LLDP notifications.
tx-mgmt-address
Syntax tx-mgmt-address [system]
no tx-mgmt-address
Context config>port>ethernet>lldp>dstmac
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies which management address to transmit.
The no form of this command reverts value to the default.
Default no tx-mgmt-address
Parameters system — Specifies to use the system IP address. If this parameter is specified, the
system address will only be transmitted once it has been configured.
tx-tlvs
Syntax tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
Context config>port>ethernet>lldp>dstmac
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies which LLDP TLVs to transmit.
The no form of this command reverts to the default.
Default no tx-tlvs
Parameters port-desc — Specifies that the LLDP agent should transmit port description TLVs.
sys-name — Specifies that the LLDP agent should transmit system name TLVs.
sys-desc — Specifies that the LLDP agent should transmit system description TLVs.