System Management
552
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Parameters num-resources — Specifies the maximum number of resources available for use by CFM
Up MEPs.
Values 0 to 2 (7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/10GE:
standalone and standalone-VC, 7210 SAS-Sx 10/100GE,
7210 SAS-Mxp)
0 to 1 (7210 SAS-M and 7210 SAS-T)
ipv6-ipv4-match-enable
Syntax ipv6-ipv4-match-enable num-resources
no ipv6-ipv4-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates resources from the SAP ingress QoS resource pool for ipv6-criteria.
Users need to use this command before using IPv6 criteria SAP ingress QoS policies.
These resources can be shared with SAP ingress policies that use IPv4 criteria.
Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Router Configuration Guide for more
information about the resource allocation for ingress filter policy and fields available for use
with ingress filter policy.
Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Quality of Service Guide for more
information about the resource allocation for SAP ingress QoS policy.
The no form of this command specifies that the software does not allocate any resources for
use by ingress SAP QoS policies using IPv6 criteria. If no resources are allocated for use, the
software fails all attempts to associate a service entity (for example, SAP and IP interface)
with an ingress filter policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this SAP
ingress Qos policy match criteria.
If the user specifies max, the software allocates one chunk when the first SAP is
associated with a SAP ingress QoS policy using this match criteria. It continues to
allocate resources to SAPs associated with SAP ingress QoS policy using this
criteria, as long as the total amount of resources allocated does not exceed the
resources allocated to SAP ingress QoS policies (configured with the command
config system resource-profile ingress-internal-tcam qos-sap-ingress-
resource command) and chunks are available for use.
Values Table 59 lists the parameter values.