Nokia 7210 - Page 563

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
563
Platforms Supported on all 7210 SAS platforms as described in this document
Description
Commands in this context configure router parameters that is applicable to the entire chassis
(in other words it applies to all IMMs).
ecmp
Syntax ecmp max-routes-dest
no ecmp
Context configure>system>resource-profile>router
configure>system>global-res-profile>router
Platforms Supported on all 7210 SAS platforms as described in this document
Description
This command configures the maximum amount of routes of same cost to the same IP
destination/prefix when path sharing is enabled using IP ECMP. To enable optimum usage
of hardware resources, software allocates hardware resources in groups of fixed number of
entries. A group is a set of IP next-hop entries used by ECMP routes. The number of IP next-
hop entries per group (which in turn dictates the maximum number of shared IP paths per IP
destination/prefix) is also specified with commands. The software uses the same group if all
the IP next-hop in use for the ECMP routes is the same.
This parameter also dictates the maximum number of paths that a single LDP FEC can use.
Note: The configure>system>resource-profile context is supported on the 7210 SAS-M,
7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE: standalone, and 7210 SAS-Sx 10/
100GE.
The configure>system>global-res-profile context is supported on the 7210 SAS-R6,
7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC.
Note: The configure>system>resource-profile context is supported on the 7210 SAS-M,
7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE: standalone, and 7210 SAS-Sx 10/
100GE.
The configure>system>global-res-profile context is supported on the 7210 SAS-R6,
7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC.