System Management
598
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
A:7210>config>system>time>ntp#
Table 71 Output Fields: NTP
Label Description
Enabled yes — NTP is enabled
no — NTP is disabled
Admin Status yes — Administrative state is enabled
no — Administrative state is disabled
NTP Server Displays NTP server state of this node
Stratum Displays stratum level of this node
Oper Status yes — The operational state is enabled
no — The operational state is disabled
Auth Check Displays the authentication requirement
System Ref. ID IP address of this node or a 4-character ASCII code showing the
state
Auth Error Displays the number of authentication errors
Auth Errors Ignored Displays the number of authentication errors ignored
Auth key ID Errors Displays the number of key identification errors
Auth Key Type Errors Displays the number of authentication key type errors
Reject The peer is rejected and will not be used for synchronization
The rejection reasons could be one of the following: the peer is
unreachable, the peer is synchronized to this local server so
synchronizing with it would create a sync loop, or the
synchronization distance is too large. This is the normal startup
state.
Invalid The peer is not maintaining an accurate clock
This peer will not be used for synchronization.
Excess The peer's synchronization distance is greater than ten other
peers
This peer will not be used for synchronization.
Outlyer The peer is discarded as an outlyer
This peer will not be used for synchronization.
Candidate The peer is accepted as a possible source of synchronization
To Next Page
Loading...
