System Management
604
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
resource-profile
Syntax resource-profile [active | configured]
resource-profile [active | configured] policy-id [detail]
Context show>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command displays the resource-profile protocol configuration and state.
Parameters active | configure — Displays active or configured values.
Active values are those in use by the system currently. Configured values are those
that have been changed by the user and have not taken effect. For the system
resource profile parameters that need a reboot to take effect, the active and
configured values can be different. It typically requires a node reboot or a card reset
for it to take effect.
policy-id — Specifies a resource profile policy. This parameter is only supported on
7210 SAS-R6 and 7210 SAS-R12.
Last Revert Result The result of the last system rollback reversion
Last Revert Initiated
Time
The date and time when the last rollback was initiated
Last Revert
Completion Time
The date and time when the last rollback was completed
Delete
Last Rollback Delete
Result
The status of the last rollback checkpoint file deletion
Rollback Files
Idx The rollback checkpoint file ID
Suffix The rollback checkpoint file suffix
Comment User comments about the rollback checkpoint file
Creation Time The date and time when the file was created
Release The software load that the checkpoint file was created in
User The user who created the file
Table 73 Output Fields: Rollback (Continued)
Label Description
To Next Page
Loading...
