Nokia 7210 - Page 67

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
CLI Usage
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
67
Default Base
telnet
Syntax telnet [ip-address | dns-name] [port] [router router-instance]
Context <GLOBAL>
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command opens a Telnet session to a remote host. Telnet servers in 7210 SAS
networks limit a Telnet clients to three login attempts. The Telnet server disconnects the
Telnet client session after the third attempt has failed. The number of attempts for a Telnet
client session is not user-configurable.
Parameters ip-address — Specifies the IP address or the DNS name (if DNS name resolution is
configured).
Values ipv4-address a.b.c.d
Values ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 .. FFFF]H
d: [0 .. 255]D
dns-name — Specifies the DNS name (if DNS name resolution is configured), up to 128
characters.
port — Specifies the TCP port number to use to Telnet to the remote host, expressed as
a decimal integer.
Default 23
Values 1 to 65535
router router-instance — Specifies the router name or service ID.
Values router-name:Base, management
service-id: 1 to 2147483647
Default Base
traceroute
Syntax traceroute {ip-address | dns-name} [ttl ttl] [wait milliseconds] [no-dns] [source ip-address]
[tos type-of-service] [router router-instance]
Context <GLOBAL>