CLI Usage
72
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
saved-ind-prompt
Syntax [no] saved-ind-prompt
Context environment
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command enables saved indicator in the prompt. When changes are made to the
configuration file a “*” appears in the prompt string indicating that the changes have not been
saved. When an admin save command is executed, the “*” disappears.
The following is a sample configuration output.
*A:ALA-48# admin save
Writing file to ftp://xxx.xxx.xx.xx/./sim48/sim48-config.cfg
Saving configuration .... Completed.
A:ALA-48#
terminal
Syntax [no] terminal
Context environment
Platforms Supported on all 7210 SAS platforms as described in this document
Description Commands in this context configure the terminal screen length and width for the current CLI
session.
length
Syntax length lines
Context environment>terminal
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command sets the terminal screen length (number of lines).
Default 24
Parameters lines — Specifies the number of lines for the terminal screen length, expressed as a
decimal integer.
Values 1 to 512
To Next Page
Loading...
