Nord Drivesystems NORDAC LINK SK250E-FDS - 2 Assembly and Installation; Installation

To Next Page

To Previous Page

2 Assembly and installation

BU 0250 en-3021 27

2 Assembly and installation

Pos: 56 /Anleitungen/ Elektronik/FU und St arter/2. Montage und Inst allation/Montage/ FDS [SK xxxE-FDS]/Monta ge und Installation_a llgemeine Infos [ SK xxxE-FDS] @ 48\mod_159714086346 6_388.docx @ 2660784 @ @ 1

No options can be retrofitted. All options must be recorded by NORD when ordering and before the

production process. The customer must not open the device at any time and does not need to. The

device is mounted by using mounting lugs that are freely accessible from the outside. The electrical

connection of mains, motor and signal cables is only possible via respective plug connectors. The

optionally available control elements (e.g. switches) are mounted in a freely accessible position.

Opening a defined blind plug is only required for the temporary connection of a diagnostic tool. The

diagnostic tools comprise:

• Parameterisation unit SK CSX-3H/ SK PAR-3H

• NORDAC ACCESS BT with the NORDCON APP

• PC with the NORDCON software

Pos: 57 /Anleitungen/ Elektronik/FU und St arter/2. Montage und Inst allation/Monta ge/FDS [SK xxxE-FDS]/Monta ge_01 [SK xxxE-FDS] @ 48\mod_159 7146467682_388.doc x @ 2660830 @ 2 @ 1

2.1 Installation

The devices are designed for an installation close to the motor and do not need a control cabinet due

to their protection class.

Distance from device:

The devices require sufficient ventilation for protection against overheating

and must therefore not be covered.

Mounting can be immediately next to each other.

The required distances for the connectio

n cable routing must be

maintained.

Installation position: • Vertical, i.e. bottom position of cable connection (power connection)

• Horizontal, i.e. top position of control elements and diagnostic LEDs