Nord Drivesystems NORDAC LINK SK250E-FDS - Certificate

NORDAC LINK (SK 250E-FDS ... SK 280E-FDS) – Users Manual for Frequency Inverters as Field Distributors
76 BU 0250 en-3021
Version 1
Using an addressing device which is
equipped with an M12 connector for
connecting to the AS-i
bus, you can
incorporate yourself into a the AS interface
network via an appropriate access. The
prerequisite for this is that the AS interface
master can be switched off.
Version 2
With an addressing device that is equipped
with an M12 connector for connecting to the
AS-i bus and an additional M12 connector
for connecting an external voltage supply,
the addressing device can be directly
incorporated in the AS-i cable.
Pos: 211 /Anleitungen/ Elektronik/F U und Starter/4. Inbetriebna hme/AS-Interfac e [alle Geräte]/Adressi erung_04 [SK 2xxE-FDS] @ 18\mod_1498740460000_3 88.docx @ 2360061 @ 5 @ 1
Resetting addresses to the factory setting (address "0")
(Only if plug connector option ”-ASI“ or “-AUX”.)
In order to be able to reset the factory setting, the 1st slave must first be addressed to "0". After
approx. 10 sec. the 1st slave is no longer visible to the master (bottom LED flashes red). After this, the
2nd slave can also be addressed to "0".
After this, the 1st slave becomes active again and is visible to the master. The 2nd slave is no longer
visible on the bus.
The original state has been restored.
Pos: 212 /Anleitungen/ Elektronik/F U und Starter/4. Inbetriebna hme/AS-Interfac e [alle Geräte]/Zerti fikat (AS-I) [SK 1xxE, SK 2xxE, SK xxxE-FDS] @ 1\mod_13457162 73105_388.doc x @ 39210 @ 3 @ 1
4.5.5 Certificate
Currently available certificates can be found on the Internet at Link "www.nord.com"
Pos: 214 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Parameter _00_Überschr ift [SK 1xxE, SK 2xxE, SK xxxE-FDS, S K 500E, SK 500P] @ 9\mod_144654060 3703_388.docx @ 260324 @ 1 @ 1
AS
-i
addressing device
AS-i
Power
AS-i
Power
AS-i
Master
AS-i addressing device
AS-i
slave
AS-i
cable
External voltage supply