Nord Drivesystems NORDAC LINK SK250E-FDS - Parameter Overview

NORDAC LINK (SK 250E-FDS ... SK 280E-FDS) – Users Manual for Frequency Inverters as Field Distributors
80 BU 0250 en-3021
Pos: 224 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Parameter übersicht_01 [SK 1 xxE, SK 2xxE, SK xxxE-FDS] @ 9\mod_144 7143569448_388.doc x @ 261844 @ 2 @ 1
5.1 Parameter overview
Pos: 225 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Param eterübersicht_02_0- Betriebsanzeigen [ SK 1x0E, SK 2xxE, SK 2xxE-FDS] @ 9\mod_1447412012081_388. docx @ 263403 @ @ 1
Operating displays
P000
Operating display
P001
Selection of display value
P002
Display factor
P003
Display factor
Pos: 226 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Parameter übersicht_02_1- Basis-Parameter [SK 1x0E, SK 2xxE, SK 2xxE-FDS, SK 500P] @ 9\mod_1447413356679_388. docx @ 263509 @ @ 1
Basic parameters
P100
Parameter set
P101
Copy parameter set
P102
Acceleration time
P103
Deceleration time
P104
Minimum frequency
P105
Maximum frequency
P106
Ramp smoothing
P107
Brake response time
P108
Disconnection mode
P109
DC brake current
P110
Time DC-brake on
P111
P-factor torque limit
P112
Torque current limit
P113
Jog frequency
P114
Brake release time
P120
Option monitoring
Pos: 227 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Parameter übersicht_02_2- Motordaten [SK 1x0E, SK 2 xxE, SK 2xxE-FDS, SK 500P] @ 9\mod_1447413634789 _388.docx @ 263542 @ @ 1
Motor data
P200
Motor list
P201
Nominal motor frequency
P202
Nominal motor speed
P203
Nominal motor current
P204
Nominal motor voltage
P205
Nominal motor power
P206
Motor cos phi
P207
Motor circuit
P208
Stator resistance
P209
No-load current
P210
Static boost
P211
Dynamic boost
P212
Slip compensation
P213
Amplification ISD control
P214
Torque lead time
P215
Boost lead time
P216
Boost lead time
P217
Oscillation damping
P218
Modulation depth
P219
Auto. flux adaptation
P220
Par. identification
P240
PMSM EMF voltage
P241
PMSM inductance
P243
Reluct. angle IPMSM
P244
PMSM peak current
P245
Power system
stabilisation PMSM VFC
P246
Moment of inertia
P247
Switchover frequency
VFC PMSM
Pos: 228 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Parameter übersicht_02_3- Regelungsparamet er [SK 2xxE, SK 2xxE-FDS] @ 38\mod_1 568384442338_388.doc x @ 2559512 @ @ 1
Speed control
P300
Servo mode
P301
Incremental encoder res.
P310
Speed controller P
P311
Speed controller I
P312
Torque current controller
P
P313
Torque current
controller I
P314
Torque current controller
limit
P315
Field curr. ctrl. P
P316
Field curr. ctrl. I
P317
Field curr. ctrl. lim.
P318
Field weakening controller
P
P319
Field weakening
controller I
P320
Weak border
P321
Speedctr. I brake off
P325
Function encoder
P326
Ratio encoder
P327
Speed slip error
P328
Speed slip delay
P330
Rotor starting position
detection
P331
Switch over freq. CFC ol
P332
Hyst. Switchover CFC ol
P333
Flux feedback CFC ol
P334
Encoder offset PMSM
P336
Rotor pos. identification
mode
P350
PLC functionality
P351
PLC setpoint selection
P353
Bus status via PLC
P355
PLC integer setpoint
P356
PLC long setpoint
P360
PLC display value
P370
PLC status
Pos: 229 /Anleitungen/ Elektronik/F U und Starter/5. Parameter/ Allgemein/Parameter übersicht_02_4- Steuerklemmen [SK 2 xxE-FDS] @ 12\mod_1467210452525_ 388.docx @ 334479 @ @ 1