Northern Meditec Taurus E - Page 103

文件编号：NR-TP-0715-008 版本：1.0
- 91 -
Source
Alarm message
L
Causes and countermeasures
Miss Beat
M*
Pacemaker Not Capture
H
Pacemaker works abnormally; check the pacemaker.
Pacemaker Not work
H
ECG Signal weak
H
The patient ECG signal is too weak, and the system
can’t analyze. Check the patient's condition,
electrodes, cables and leads.
ST-I Too High
M*
ST value is higher than the upper alarm limit or lower
than the lower alarm limit. Check the patient's
physiological condition, and check if the patient
category and alarm limit settings are appropriate for
the patient.
ST-I Too Low
ST-II Too High
ST-II Too Low
ST-III Too High
ST-III Too Low
Resp
RR Too High
M*
Patient PR value is higher than the upper alarm limit or
lower than the lower alarm limit. Check the patient's
physiological condition, and check if the patient
category and alarm limit settings are appropriate for
the patient.
RR Too Low
Apnea(RESP)
H
The patient's respiratory signal is too weak, and the
system can’t analyze. Check the patient's condition,
electrodes, cables and leads.
RESP ARTIFACT
H*
Respiration heartbeat interference
Temp
T1 Too High
M*
T1/T2 value is higher than the upper alarm limit or
lower than the lower alarm limit. Check the patient's
physiological condition, and check if the patient
category and alarm limit settings are appropriate for
the patient.
T1 Too Low
T2 Too High
T2 Too Low
TD Too High
TD value is higher than the upper alarm limit or lower
than the lower alarm limit. Check the patient's
physiological condition, and check if the patient
category and alarm limit settings are appropriate for
the patient.
SpO2
SPO2 Too High
M*
SpO2 value is higher than the upper alarm limit or
lower than the lower alarm limit. Check the patient's
physiological condition, and check if the patient
SPO2 Too Low