Kronos Series 3
50
6 SFTP Access
The clocks supports SFTP (Secure File Transfer Protocol) for accessing the configuration and log files, and
for performing firmware upgrades.
The SFTP server runs on port 22 (default port for SFTP).
The following usernames are predefined:
Active configuration file
Default configuration file. When the reset
button on the back of the clock is pressed, then
this file is copied to kronos3.cfg.
Table 31: Default SFTP usernames and passwords
Note: It is recommended to change the default passwords at commissioning as described in
section Access Passwords (Online) and Access Passwords (Offline).
This requires a SFTP client on the engineering PC. A SFTP client such as FileZilla (www.filezilla.org) or
WinSCP (www.winscp.net) can be downloaded from the respective website. You can download an
installation package or use the “portable” executable if available. The latter is just a .exe file that can be
copied and run without needing to install anything. The following screens show the use of WinSCP.
When the program is started, you will be prompted for a hostname, username, and password (Figure 29).
To Next Page
Loading...