EasyManua.ls Logo

Novatech Kronos 2 Series - Appendix B - Technical Specifications

Novatech Kronos 2 Series
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Kronos Series 3
57
Appendix B – Technical Specifications
The clock has the following technical specifications.
Component
Specification
Satellite receiver
▪ 72-channel satellite receiver
▪ L1-C/A (1575.42 MHz) GPS
▪ E1-B/C (1575.42 MHz) Galileo
▪ L1OF (1602 MHz) GLONASS
▪ B1 (1561.098 MHz) BeiDou
▪ -162dBm tracking sensitivity
▪ Single-satellite operation supported
▪ 20ns accuracy (99%, clear sky)
▪ Antenna cable open and short-circuit detection
▪ TNC coaxial connector
Internal oscillator
▪ TCXO: 0.1ppm typical drift
▪ OCXO: 1ppb typical drift
▪ User-defined out-of-bounds alarm
Isolated electrical
outputs
▪ IRIG-B000, 002,004, or 006 encoding
▪ 5V and RS-485/422 signal levels
▪ 15Ω output impedance
▪ Fully isolated from remaining outputs
▪ Protected against short-circuit and overload
▪ BNC coaxial connector (for 5V level signal) and/or 0.2inch (5.08mm) pitch
Fiber-optic outputs
▪ 820nm wavelength
▪ Optical power:
o -15.8dBm into 50/125μm fiber
o -12dBm into 62.5/125μm fiber
▪ Up to 1600 yards (1500m) multimode optical fiber
▪ ST connectors
Amplitude
modulated outputs
▪ IRIG-B120, 122,124, or 126 encoding
▪ 5Vpp (no load) / 3.2Vpp (50Ω load) output voltage
▪ 25Ω output impedance
▪ BNC connectors

Table of Contents