142 Quadro Workstation User’s Guide
Chapter 7
Configuring Key ForceWare Graphics Driver Features
6 To enable these custom resolutions, see the next section “Enabling Custom Screen
Resolutions” on page 142.
Enabling Custom Screen Resolutions
After you have added one or more custom screen resolutions, follow these steps to
enable these resolutions.
1 Select the Only show custom modes check box to access those screen resolutions
& refresh rates that you have added using the Add button.
Note: Custom resolutions that you can select are limited to resolutions divisible by
the number “8”.
2 Click Apply.
3 Move the Screen resolution slider to a custom resolution you added.
4 Click Apply.
The screen may go blank for a few seconds for the new setting to take effect.
Removing Custom Screen Resolutions & Refresh Rates
1 Once you have added one or more custom screen resolutions and refresh rates,
follow the remaining steps to delete any of them:
2 From the Screen Resolution & Refresh Rates page, make sure the Only show
custom modes check box is selected.
3 Move the Screen resolution slider to a custom resolution that you want to delete.
4 Click the Remove button to delete that resolution.
5 Repeat steps 3 and 4 for additional resolutions you want to remove.
QuadroGuide_.book Page 142 Monday, April 3, 2006 12:21 PM
To Next Page
Loading...
Need help?
General
