144 Quadro Workstation User’s Guide
Chapter 7
Configuring Key ForceWare Graphics Driver Features
Figure 7.26
Advanced Timing — Custom Modes/Timings & Timing Standards
Display Mode & Timing Parameters
Click the Mode & timing list if you want to select a “custom” timing value or an
“EIA-861B”
timing. These settings are explained below.
Note: If you rather use “standard” timings (such as DMT, GTF, CVT, and EDID), see
“Display Timing Standards” on page 147 in the next section.
• Custom values — If you are an advanced user and would prefer to enter custom
timing values in the fields provided on the Advanced Timing page, follow these
steps:
1 Select Custom values from the Mode & timing list and click Apply.
2 Enter the values you want in the various fields as described in Table 7.1
3 When the confirmation prompt appears, click Yes. Your custom settings are
now in effect.
QuadroGuide_.book Page 144 Monday, April 3, 2006 12:21 PM
To Next Page
Loading...
