NVIDIA Corporation 59
Chapter 4
Using nView Multi-Display Settings
which also enables the equivalent Disable auto-panning on the secondary device
(viewport lock) check box.
Switching Between nView Dualview and Span/Clone
Modes — Windows 2000
Note: Under Windows 2000, switching between nView Span/Clone and Dualview
modes requires restarting your computer. (Under certain configurations,
switching between Single Display mode and Dualview/Span/Clone may also
require restarting your computer.)
1 From your Windows 2000 desktop, right click to view the Windows desktop
menu, then click Properties > Settings > Advanced and then the NVIDIA GPU tab.
2 Click nView Display Settings from the NVIDIA menu.
3 From the nView Modes list, select Clone, Horizontal Span, or Vertical Span
mode.
Note: If you just switched to Clone, Horizontal Span, Vertical Span, or, under
certain circumstances, Single Display mode from Dualview, you’ll need to
follow the prompts to restart your computer.
4 When you have returned to your desktop, go to the nView Display Settings page
and select Clone, Horizontal Span, or Vertical Span mode from the nView Modes
list.
Note: To switch back to Dualview mode, you will need to restart your computer,
as prompted.
Enabling nView Multiview Mode —
Only
for NVIDIA
Quadro NVS-based Graphics Cards
Note: nView Multiview mode is a custom mode that is only available when using the
NVIDIA Quadro NVS GPU-based series of graphics cards.
The NVIDIA Quadro NVS is a series of multi-display graphics cards for professionals
in the financial and non-linear editing (NLE) markets.
QuadroGuide_.book Page 59 Monday, April 3, 2006 12:21 PM
To Next Page
Loading...
Need help?
General
