EasyManuals Logo

NXP Semiconductors LPC5411 Series User Manual

NXP Semiconductors LPC5411 Series
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
LPC5411x All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2018. All rights reserved.
Product data sheet Rev. 2.1 — 9 May 2018 99 of 105
NXP Semiconductors
LPC5411x
32-bit ARM Cortex-M4/M0+ microcontroller
Modifications: Updated Section 2 “Features and benefits”: deleted text: Real-Time Clock (RTC) running from
the 32.768 kHz clock from the list item: The Micro-Tick Timer running from the watchdog
oscillator can be used to wake-up the device from any reduced power modes. See
Removed code executing in flash and SRAM from deep-sleep mode in Table 23 “Dynamic
characteristic: Typical wake-up times from low power modes”.
Updated Table 13 “CoreMark score”: In ARM Cortex-M4 in active mode; ARM Cortex-M0+ in
sleep mode, changed CCLK = 96 MHz; 5 system clock flash access time to CCLK = 96 MHz; 6
system clock flash access time. In ARM Cortex-M0+ in active mode; ARM Cortex-M4 in sleep
mode, changed CCLK = 96 MHz; 5 system clock flash access time to CCLK = 96 MHz; 6 system
clock flash access time.
Added text in Section 2 “Features and benefits” and Section 7.11 “On-chip ROM”: ROM based
USB drivers (HID, CDC, MSC, DFU).
Replaced list item in ROM API support in Section 2 “Features and benefits” and Section 7.11
“On-chip ROM”: Legacy, Single, and Dual image boot.
Changed text in clock generation in Section 2 “Features and benefits”, Section 7.18.3.1
“Features”, and Section 7.21.1.2 “Watchdog oscillator (WDTOSC)”: was, Watchdog oscillator
(WDTOSC) with a frequency range of 200 kHz to 1.5 MHz, now, Watchdog oscillator (WDTOSC)
with a frequency range of 6kHz to 1.5 MHz.
Updated Table 28 “Dynamic characteristics: Watchdog oscillator”. The min value of internal
watchdog oscillator frequency is 6 kHz.
Updated Section 7.13.2 “Deep-sleep mode”.
Updated Table 7 “Peripheral configuration in reduced power modes” and added Table 8
“Wake-up sources for reduced power modes”.
Updated Figure 32 “Power, clock, and debug connections”.
Updated Figure 34 “USB interface on a self-powered device where USB_VBUS = 5 V” and
Figure 35 “USB interface on a bus-powered device”.
LPC5411x v.1.5 20160718 Product data sheet - LPC5411x v.1.4
Modifications:
Updated Table 16 “Static characteristics: Power consumption in deep-sleep and deep
power-down modes”: IDD typical values at deep-sleep mode, flash is powered down.
Table 43. Revision history
…continued
Document ID Release date Data sheet status Change notice Supersedes

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NXP Semiconductors LPC5411 Series and is the answer not in the manual?

NXP Semiconductors LPC5411 Series Specifications

General IconGeneral
BrandNXP Semiconductors
ModelLPC5411 Series
CategoryMicrocontrollers
LanguageEnglish

Related product manuals