EN-100 EXPLORER BALANCES
5.9.4 Handshake
Set the flow control method.
NONE = no handshaking
XON-XOFF = XON/XOFF handshaking
HARDWARE = hardware handshaking (COM1 menu only)
5.9.5 Alternate Command
Enter this sub-menu to set a different command character for the P (Print), T (Tare) or Z (Zero)
commands.
Note: The selected character can only be used for one command.
Alternate Print Command
Set the alternate command character for Print.
Settings of A to Z are available. The default setting is P.
Alternate Tare Command
Set the alternate command character for Tare.
Settings of A to Z are available. The default setting is T.
Alternate Zero Command
Set the alternate command character for Zero.
Settings of A to Z are available. The default setting is Z.
Print Settings Menu:
Note: If LEGAL FOR TRADE is set to ON, the print Output-Stable setting is not reset.
5.9.6 Print Output
Print Stable Weight Only
Set the printing criteria.
OFF = values are printed immediately, regardless of stability.
ON = values are printed only when the stability criteria are met.
Print Numeric Value Only
Set the printing criteria.
OFF = All data values are printed
ON = Only numeric data values are printed
To Next Page