- 296 -
Table of setting items in the device setup screen
1
2
3
5
4
Convenient print
functions
Appendix Index
Checking and
Changing Printer
Settings Using
the Control Panel
Network
Setup
Matching
Colors
Using Utility
Software
Panel Setup
z
Shaded areas are factory-set values.
Item Details
Near life status Enable
Disable
Sets the panel display control when a near life
warning occurs for the image drum, xer unit, or
belt.
Near life LED
Enable
Disable
Sets the alarm lamp ON control when a near life
warning occurs for the toner, image drum, xer
unit, belt, or waste toner box.
Standby screen display
Toner gage
Paper size
Sets the information displayed in the standby
screen.
Panel brightness (during operations)
5
to
31
Adjusts the brightness (backlight luminosity) of the
control panel LCD.
The set brightness is applied during control panel
operations.
Panel brightness (during power save)
0
to
1
to
31
Adjusts the brightness (backlight luminosity) of the
control panel LCD.
The set brightness is applied after the panel
backlight timer time has eplased from the last
operation.
Panel Backlight Timer
10
to
30
to
300
Adjusts the time (s) from the last operation to
when the panel brightness (during power save) is
applied.
Front Lamp
Mode 1
Mode 2
OFF
Sets the printer front lamp operations.
Mode 1:
Lit when in standby mode, ashes slowly during
processing, and ashes rapidly when an error
occurs.
Mode 2:
Lit when in standby mode, ashes slowly during
processing, and OFF when an error occurs.
OFF:
Normally OFF.
Time settings
z
Shaded areas are factory-set values.
Item Details
Date display format yyyy/mm/dd
mm/dd/yyyy
dd/mm/yyyy
Sets the date display mode.
Time zone
-12:00
to
+0:00
to
+13:00
Sets the time difference from GMT in 15-minute
units. If the time zone setting is changed, the tome
differences before and after the change is reected
in the current time.
Memo
z
The factory default is set to +9.00.
Summertime ON
OFF
Sets whether to display summertime.
ON:
Advances the current time by 1 hour.
OFF:
Turns back the current time by 1 hour.
Time settings
2000/01/01 00 :00
to
2009/01/01 00 :00
to
2091/12/31 23 :59
Sets the time.
Memo
z
The factory default is to set the time.