5238-E P-169
SECTION 8 LATHE AUTO-PROGRAMMING FUNCTION (LAP)
3. List of Cutting Modes
In LAP, longitudinal or transverse mode can be designated for each of the AP modes I through V.
The modes that can be used with LAP are summarized in the table below.
Longitudinal Mode Transverse Mode
LAP
4
LAP
3
AP
mod
e I
(1) (6)
AP
mod
e II
(2) (7)
AP
mod
e III
(3) (8)
AP
mod
e IV
(4) (9)
AP
mod
e V
(5) (10)
* The numbers assigned to each mode here, (1) to (10), correspond to their descriptions on the
following pages.
To Next Page
Loading...