Okuma OSP-P20L - Schedule Program End Block

5238-E P-319
SECTION 13 SCHEDULE PROGRAMS
5. Schedule Program End Block
[Function]
At the end of a schedule program, an "END" block must always be specified. All blocks specified
following the "END" block are invalid.
[Programming format]
END
6. Program Example
The procedure to create a schedule program is explained below.
Assume that the NC lathe is equipped with a bar feeder and three different workpieces are
machined according to the programmed schedule.
[Program sequence]
Procedure :
1 Determine the file name and the program name (number) of the program to be used for
machining three kinds of parts.
2 Create the program for each part based on the part drawing.
3 To machine these three kinds of parts, determine the order and the number of parts to be
machined.
4 Make the schedule program next. Determine the file name of the schedule program.
Part A A.MIN, O100
Part B B.MIN, O200
Part C C.MIN, O300
Part A 20 pcs.
Part B 15 pcs.
Part C 25 pcs.
File
name
SHAFT-1.SDF