Troubleshooting
OPERATION GUIDE 9-7
The waste toner box is full. Replace it with a new waste
toner box.
8-5
250 copies have been stored on output tray. Remove
the paper, press [Start] and resume copying.
–
Originals were set in the optional Document Processor
when copying on 2-sides (front and back sides), when
copying from the platen in 2-Sided copy, 2 in 1, 4 in 1 or
when collating copies. Remove the originals from the
Document Processor, replace the originals on the
Original Table after exiting the front and back copying, 2-
Sided copy, 2 in 1, 4 in 1 or Collate Mode and resume
copying.
–
If the optional Document Processor is being used, there
are originals left on the original table. Remove the
originals, return them to the original table and try
copying them again.
–
Check the paper cassette that corresponds to the
lighting indicator. Set the cassette.
2-2
The Toner Container has not been set. Set the Toner
Container.
8-5
The Add Toner indicator blinks on
and off.
There is very little toner remaining. Copying can be
continued for a short while before running out of toner.
Replace the toner container with a new one as soon as
possible.
8-5
The Periodic Maintenance
indicator blinks on and off.
This is a notification that the time for periodic
maintenance is approaching.
–
The Periodic Maintenance
indicator lights up.
It is time for Periodic Maintenance. Contact your service
representative.
–
“= = =” appears on the copy
quantity display.
Job Accounting being set. Use the numeric keys to enter
the assigned Section Code to perform copying
operations. Press [Job Accounting] after copying is
finished to display “= = =” again.
6-6
“-” appears on the copy quantity
display.
The copier is in the Sleep Mode setting. Press [Energy
saver] to exit the mode.
3-9
Display Corrective Procedure
Reference
Page
Replace waste
toner box.
Remove paper on
top tray; Start.
Reseat originals
on DP.
Return all
originals to DP.
Set paper
cassette.
Set toner
container.