Copying Functions
4-22 OPERATION GUIDE
Program Function
Copy settings that are frequently used can be registered and then recalled
by pressing [Program]. Even types of copies can be stored.
Registering a program
1
Set the Copy Mode to be registered.
2
Press [Program] for 3 seconds.
3
Input the program number (0 to 9) using the numeric keys and press the
[Program] key for 3 seconds.
The display of the number input will blink 2 times and the program will be
registered.
NOTE: If the same number as a program already registered is input, the
prior program is overwritten.
Using programmed setting to make copies
1
Press [Program].
2
Press U or V, select the number of the program to be used and then press
[OK]. Input can also be done using the numeric keys.
3
Set the original and press [Start]. The copy will be made using the
program that has been set.
To Next Page
Loading...
