System Setting
5-2 OPERATION GUIDE
System Menu
The copier will enter System Menu after warm up has been completed or
when [Reset] has been pressed. The settings automatically set for the
copier in System Menu are called the Default Settings. These settings can
be freely changed to match the usage of the copier.
System Menu Items
The following are the System Menu Items.
Change the settings as necessary in order to achieve the most efficient use
of the copier. The factory default setting is indicated by an asterisk (*).
System Menu
Items
Description Available settings
Reference
Page
01.Copy Status Outputs the content of the Default Settings. --- 5-8
02.Language Set the language of the message display. [Inch specifications]
English*
Francais
Espanol
Japanese
Portugues
[Metric specifications]
English
Deutsch
Francais
Espanol
Italiano
5-8
03.Image Quality Sets the manuscript image quality that will be
selected at the time the copier is turned on.
Text + Ph Dens.*
Photo Density
Text Density
5-9
04.Initial Dens. Sets the copy exposure at the time the copier is
turned on to Manual or Automatic.
There will be no display when Photo Density has
been selected in 03.Image Quality.
Manual*
Auto
5-9
05.EcoPrint Selects the initial value of the EcoPrint Mode when
the power is turned on. The initial value of the Eco
Mode can be set to on (Enable). Exposures will be
lighter and less toner will be consumed when the
EcoPrint Mode is used.
On: Enabled
Off: Disabled*
5-10
06.Density steps Changes the number of the adjustment steps for the
copy’s exposure. 0.5 - Setting this step enables even
finer adjustment of the exposure.
1 Step*
0.5 Step
5-10
07.Auto Density Adjusts the overall exposure of the copy when Auto
Exposure Mode is used.
1(lightest) to 7(darkest)
(*4)
5-11
08.Text+Ph Dens. Adjusts the central exposure value for the copier’s
manual exposure (Text and Photo).
1(lightest) to 7(darkest)
(*4)
5-11
09.Photo Density Adjusts the central exposure value for the copier’s
manual exposure (Photo).
1(lightest) to 7(darkest)
(*4)
5-11
To Next Page
Loading...
Need help?
General