System Setting
5-22 OPERATION GUIDE
4
Press U or V and select a time interval from 10 to 270 (seconds).
NOTE: Set the time interval to a longer length of time in the case where
the copier is used often and to a shorter time interval when it is used
infrequently.
This can be set when the Auto Clear setting has been set to On. (Refer to
Auto Clear Setting on page 5-20.)
5
Press [OK]. The display will return to that of Step 2.
Low Power Mode Transition Time
Set the time interval from the time operations end to the automatic
engagement of the Low Power Mode.
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display 53.LowPower
Time.
3
Press [OK].
4
Press U or V and select a time interval from 1 minute to 240 minutes.
NOTE: The time intervals available are: 1, 5, 15, 30, 45, 60, 90, 120,
180 and 240 minutes.
5
Press [OK]. The display will return to that of Step 2.
Sleep Mode Transition Time
Set the time interval for automatically entering Sleep Mode when copying
is completed or after operations have been finished.
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display
54.AutoSleepTime.
3
Press [OK].
4
Press U or V and select a time interval from 1 minutes to 240 minutes.
System Menu:
53.LowPower Time
System Menu:
54.AutoSleepTime
To Next Page
Loading...
Need help?
General