System Setting
OPERATION GUIDE 5-23
NOTE: This can be set when the Auto Sleep setting has been set to On.
(Refer to Auto Sleep Setting on page 5-21.)
The time intervals that can be set are 1, 5, 15, 30, 45, 60, 90, 120, 180
and 240 minutes.
5
Press [OK]. The display will return to that of Step 2.
Alarm
The Alarm can be set to sound when a key on the Operation Panel is
pressed or in cases when errors occur, etc.
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display 55.Alarm.
3
Press [OK].
4
Press U or V and select On in the case where the alarm is to be sounded
or Off when it isn’t to be sounded.
5
Press [OK]. The display will return to that of Step 2.
Toner Coverage Report
Output the report that shows the number of copies made and the average
concentration of toner used for each paper size.
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display
56.CoverageRepo.
NOTE: Check to make sure that Letter/A4 size paper is loaded in the
cassette.
3
Press [OK].
4
Press U or V and select Yes.
5
Press [OK]. The report will be output and the display will return to that of
Step 2.
System Menu:
55.Alarm
System Menu:
56.CoverageRepo
To Next Page
Loading...
Need help?
General