Basic Operation
3-8 OPERATION GUIDE
Low Power Mode
Pressing [Energy Saver] will put the copier into a resting state even when
the Power Switch is ON. The No. of Copies display on the Operation Panel
will change to “- - -”, the Energy Saver indicator will light up and all other
indicators and message display will be turned off.
Press any key on the Operation Panel or open and close the Original
Cover in order to resume copying operations. In the case where the
optional Document Processor is installed, placing an original in the
Document Processor will also revert the copier to the state where copies
can be made. The recovery time before copies can be made is within 10
seconds.
NOTE: A function to automatically enter the Low Power Mode after a set
interval in which no copies have been produced has passed is also
included. (Refer to Low Power Mode Transition Time on page 5-22.)
To Next Page
Loading...
Need help?
General