DMTA-10009-01EN [U8778346], Rev. D, November 2016
Instrument Description
21
•EMAT transducer capability
• Measurement-related status flags and alarms
• Full VGA color transflective LED back-lite display
• Automatic probe recognition for the standard D79X and MTD705 series
transducers
• Dynamic default gain optimization
• V-path calibration to build custom V-path correction tables for any dual element
transducer
• Warning against calibration doubling
• Calibration for unknown material sound velocity and/or transducer zero
• Echo-to-echo measurements
• Fast scan mode with 30 readings per second
• Manual gain adjustment in 1-dB steps
• Hold or blank thickness display during loss-of-signal (LOS) conditions
• Hold minimum, maximum, or both minimum and maximum functions
• Differential thickness display relative to the set point in absolute or percentage
ratio
• Selection of password-protected lockout functions
• Selectable resolution: low of 0.1 mm (0.01 in.), standard of 0.01 mm (0.001 in.), or
high (optional) of 0.001 mm (0.0001 in.) [option not available for all transducers]
A-Scan and B-Scan Display Options
• Real-time A-scan waveform display for verification of critical measurements
• Manual freeze mode with post processing
• Manual zoom and range control of waveform display
• Auto hold on LOS and auto zoom (measured echo centering)
• Extended blank
• Blank after first received echo in echo-to-echo mode
• Receiver gain readout
• Ability to capture and display waveform associated with minimum thickness
during scanned measurements
• Display stored and downloaded waveforms
To Next Page
Loading...
