Olympus CV-180 - Page 158

150
Chapter 5 Functions
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
2. While the window opens, press the “F2” key again to show the scope
information screen on the monitor (see Figure 5.102).
Figure 5.102
3. Click each input area to modify.
4. Modify the data using the keyboard.
5. Click “OK” to store the entered data into the scope ID chip in the endoscope.
While the data is being stored, the message “Please wait” appears on the
monitor.
6. Click “Back” to return to the endoscopic image.
While the message “Please wait” is displayed, do not turn
OFF the video system center.
To cancel the input, click “Back” to return to the endoscopic
image display.