Olympus CV-180 - Installation of the Equipment

Chapter 8 Installation and Connection
159
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
8.2 Installation of the equipment
• Do not place any object on the top of the video system
center. Otherwise, equipment deformation and damage can
result.
• Keep the ventilation grills of the video system center clear.
The ventilation grills are located on the side panels. Blockage
can cause overheating and equipment damage.
• Clean and vacuum dust the ventilation grills using a vacuum
cleaner. Otherwise, the video system center may break down
from over heating.
• Place the video system center on a stable, level surface
using the foot holders (MAJ-1433). Otherwise, the video
system center may topple down or drop, and user or patient
injury may occur, or equipment damage can result.
• If a trolley other than the mobile workstation (WM-NP1 or
WM-WP1) is used, confirm that the trolley can withstand the
weight of the equipment installed on it.
• Do not install the video system center near a source of strong
magnetic wave (microwave treatment device, short wave
treatment device, MRI, radio equipment, etc.). Otherwise, the
video system center may malfunction.