160
Chapter 8 Installation and Connection
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
Installation on the mobile workstation (WM-NP1, WM-WP1)
1.
Place the mobile workstation on a level and flat floor. Lock the caster brakes
by pushing them down (see Figure 8.2).
Figure 8.2
2. Install the mobile shelf of the mobile workstation according to the
configuration of the equipment installed on it as described in the mobile
workstation's instruction manual.
3. Place the pattern sheet on the light source. The pattern sheet is packed with
the foot holder (MAJ-1433).
4. Peel the paper from the back of the foot holders and attach them firmly at
the right position on the light source using the pattern sheet (see Figure
8.3).
Figure 8.3
5. Remove the pattern sheet.
6. Place the light source on the mobile shelf of the mobile workstation as
described in the light source's instruction manual.
To Next Page
Loading...
