Olympus CV-180 - Page 171

Chapter 8 Installation and Connection
163
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
White cap set (MAJ-941)
The white cap (MH-155) is used for the white balance adjustment. The white cap
is attached to the video system center by the white cap holder (MAJ-960).
Do not hang any object other than the white cap on the white
cap holder.
1. Fit ditches A or B on the projections on the left side of the instrument (see
Figure 8.7).
Figure 8.7
2. Push the white cap holder backward until it clicks.
3. Insert the disk part at the top of the white cap into the ditches on the opening
of the white cap holder until it clicks (see Figure 8.8).
Figure 8.8
Ditch Remark
A The white cap projects forward from the front panel.
B The white cap does not project forward from the front panel.
Table 8.2
Projections
(a)
(b)
Ditches B
Ditches A
White cap
White cap holder