190
Chapter 8 Installation and Connection
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
• Do not extend a single wall mains outlet into multiple outlets
for connecting the power cords of both the electrosurgical
unit and light source. Otherwise, malfunction of the
equipment may result.
When the mobile workstation (WM-NP1, WM-WP1) is used
1. Confirm that the video system center is OFF.
2. Connect the power cord provided with the mobile workstation to the AC
power inlet of the video system center and the AC mains outlet of the mobile
workstation (see Figure 8.27).
Figure 8.27
3. Connect the power cords provided with the mobile workstation to the AC
power inlets of the ancillary equipment and the AC mains outlets of the
mobile workstation.
4. Connect the power cord of the mobile workstation to the wall mains outlet.
To Next Page
Loading...
