212
Chapter 9 Function setup
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
Video signal type
1. Click “ ” of “Signal”. The video signals appear in the pull-down menu.
2. Click the desired video signal. The selected video signal is displayed.
• When using the VTR remote cable MH-989 or MAJ-906, set
the RS-232C transfer rate of the videocassette recorder as
shown below following the instructions given in the
instruction manual for the VTR remote cable.
Baud rate: 9600 bps
• When using the VTR remote cable MH-922, set the
videocassette recorder’s foot switch control mode in “Low
level trigger mode” following the instructions given in the
instruction manual for the videocassette recorder (SVO-
9500MD).
• For further information, refer to the instruction manual for the
VTR remote cable.
Setting value Explanation
S-Video The type of input signal when playing back is S-video.
Composite The type of input signal when playing back is composite.
Table 9.18
To Next Page
Loading...
