230
Chapter 9 Function setup
EVIS EXERA II VIDEO SYSTEM CENTER CV-180
1. Click “Image size” on the system setup menu. The setting items appear on
the right side of the window (see Figure 9.23).
Figure 9.23
2. Click “ ” of the scope type to use (see Figure 9.23).The image sizes
appear in the pull-down menu.
3. Click the desired image size. The selected image size is displayed.
4. Follow steps 1. to 3. to set the image size of all endoscopes to be used.
• The image size can be changed during observation. For
details, see “Image size (“F8”)” on page 94
• When this instrument is turned ON, the image size before
turning the video system center OFF comes up when turning
the instrument ON. When the user preset is called up, the
image size set in this menu comes up.
• “Scope 5” is not displayed on this menu because the
endoscopes of “Scope 5” are compatible only with “Full” size.
To Next Page
Loading...
