24
Chapter 3 Installation and Connection
VISERA XENON LIGHT SOURCE CLV-S40
1. Connect the light guide cable to the rigid endoscope.
2. Insert the light guide connector into the output connector on the front panel
of the light source until it stops (see Figure 3.7).
Figure 3.7
The following light guide cables are compatible with the high
intensity mode:
A3290/91/92/93/94/95/96/97/98
î Connection to a videoscope
Insert the light guide connector into the output connector on the front panel of the
light source until it stops (see Figure 3.8).
Figure 3.8
To Next Page
Loading...
