Olympus VISERA CLV-S40 - Main Lamp Replacement Steps

Chapter 6 Lamp Replacement
61
VISERA XENON LIGHT SOURCE CLV-S40
Figure 6.2
Figure 6.3
3. After allowing sufficient time for the lamp and heat sinks (a) and (b) to cool,
loosen clamping knob (b) (front panel side) by turning it counterclockwise.
Then loosen clamping knobs (c) and (d) by turning them counterclockwise.
4. Take out the lamp, with heat sinks (a) and (b) attached.
5. Using the hexagon wrench, loosen the three bolts on the lamp’s (“+”) side
(heat sink (b) side) and remove heat sink (b) (see Figure 6.4).
Figure 6.4
Lamp cover knob (a)
Lock mark
Lamp access cover
Clamping knob (b)
Lamp access
cover
Clamping knob (d)
Hexagon wrench
Clamping knob (c)
Heat sink (b)
Heat sink (a)
Bolt
Clamp