Chapter 6 Lamp Replacement
63
VISERA XENON LIGHT SOURCE CLV-S40
11. Confirm that the surfaces of heat sinks (a) and (b) are parallel, then tighten
the clamp on heat sink (a) (see Figure 6.6). Insert this assembly into the
lamp housing fitting the guide pin into the guide pin hole of heat sink (b),
then securely tighten clamping knobs (c) and (d), in that order (see Figure
6.7).
• To avoid causing damage to the light source and/or fire,
make sure that the “–” side of the lamp faces the front panel.
• Be sure to tighten the clamping knobs and the clamp.
Unless they are tightened, the lamp will not light correctly,
may have a short life, or could explode.
Figure 6.6
Figure 6.7
12. Tighten clamping knob (b) firmly to connect heat sink (a) tightly (see Figure
6.7).
Clamping knob (b)
Lamp access
cover
Clamping knob (d)
Clamping knob (c)
Hexagon wrench
To Next Page
Loading...
