83
The Undo Pre menu lets you listen to the audio of each individual Undo band before it
enterstheentireUndochain.
TheUndoPostmenuletsyoulistentotheaudiooftheUndosection,ortoeachindividual
Undo band after it has been processed by Undo but before it enters the main audio
processingcore.
TheMultibandDRCSolomenuletsyoulistentotheaudioaftertheParametricEQ,ineach
oftheAGC,Wideband1,andWideband2sidechains,andattheoutputofeachindividual
bandoftheMultibandprocessingsection.
Streaming1,Streaming2,andStreaming3PatchPoints
You can feed each of the three Monitor Outputs audio from various points within each of the
Streamingprocessingcores.
TheI/OmenuallowsyoutolistentoeithertheProgramInputortheDigitalOutputofeach
Streamingprocessingcore.
TheDeclippermenuletsyoumonitortheaudioeitherbeforeoraftertheDeclipper.
The Undo Pre menu lets you listen to the audio of each individual Undo band before it
enterstheentireUndochain.
TheUndoPostmenuletsyoulistentotheaudiooftheUndosection,ortoeachindividual
Undo band after it has been processed by Undo but before it enters the main audio
processingcore.
The Undo Control Signal menu lets you monitor the control signal of each of the Undo
bands. Because thispatch pointmonitors asignal ratherthan audio,it isdesigned tobe
viewedinanOscilloscopewindow.
TheMultibandDRCSolomenuletsyoulistentotheaudioaftertheParametricEQ,ineach
oftheAGC,Wideband1,andWideband2sidechains,andattheoutputofeachindividual
bandoftheMultibandprocessingsection.
LoadPresetMenu
Because Omnia.9 provides all of the tools – minus a calibrated microphone – to perform
speaker/roomcalibrationsforeachoftheMonitorOutputs,italsoprovidesawayforyoutostore
thosecalibratedsettingsintheformofpresets.Itisimportanttorememberthatthismenurefers
topresetsyou createandsaveyourselfforspeakercalibrationswithineach ofthethreeMonitor
Outputs. These are not the same as your processing presets! However, the menus work in the
sameway.